You are purchasing an Exchange service; we will send you a Rebuilt and Tested Porsche 944 Turbo (0 261 201 014 / 0261201014/ 0.261.201.014) KLR ready to be installed in your vehicle.
All of our rebuilt units feature:
5-year warranty.
Visual inspection of critical areas on circuit boards.
Cleaning of dust, debris or corrosion.
Repair of associated problems and resoldering of critical components.
Upgrade of obsolete and worn electronic components.
100% bench warranty and vehicle testing.
Once you receive our rebuilt KLR, install it on your vehicle and then send the defective KLR back to us for your core refund.
CORE CHARGE
CORE CHARGE is a deposit that we collect to ensure that the exchange is complete. When we receive your Porsche KLR/ ECU core at our office, we will refund the core charge to your credit card.
Your old Porsche KLR/ ECU must be returned within 5 days of the delivery date to receive a refund of the core deposit. You may be subject to additional charges, in addition to a canceled warranty, if you do not return your old KLR/ ECU within 5 days of receiving the new rebuilt KLR/ ECU.
KLR/ ECU's returned in NON-REBUILDABLE condition, such as HEAVY WATER DAMAGE, FIRE DAMAGE or INTERNALLY MANIPULATED; you may receive a partial refund or no refund at all.
FOR INTERNATIONAL SHIPMENTS ONLY There is an additional $ 100 core charge included in shipping charges that count towards the core charge deposit. Once we receive the DEFECTIVE ECU core back, you will be refunded the original core charge plus the additional $ 100.
INSTRUCTIONS
The DME/ ECU/ KRL of your 944 is located under the carpet in the footrest area on the passenger's side. To remove it, you will need the following tools:
Medium size Phillips screwdriver
Medium size Flat screwdriver
Start by pushing the passenger seat back as far as you can, remove the floor mat. The carpet is attached at the top with Velcro. Pull the carpet back to locate the protective wood foot board. The foot board will be held by 4 Phillips screws and washers, remove and set aside.
The DME/ ECU is attached to a supporting metal frame, locate and remove the 2 Phillips screws at the bottom of the frame and the 2 plastic screw retainers that secure the metal frame. With the frame released from its location, gently pull it back; then locate and remove the remaining 4 Phillips screws that hold the DME / ECU against the metal frame. After releasing the DME / ECU from the metal frame, carefully remove the main connector by pushing the silver tab on the side of the DME and carefully pulling the main connector.
